M916G UTR556 AEG With Mosfet (Double Eagle)

Weight: 2300 g

Magazine model: steel

Gearbox version: v.2

Bearings diameter: 8 mm

Accumulator connector type: T-connerctor

Accumulator included in set: NO

Material: nylon, aluminum

Power: ~1J (328fps)

Fire mode: auto, single

Amunicja: .25g, .23g

The new UTR (Ultra Tactical Rifle) series with a modern design from the Double Eagle company. The main elements, such as the upper lower receivers and the handguard, are made of reinforced nylon instead of metal alloys, so the replica weighs only about 2 kg. The AX//15 handguard in the MLOK system and the AE//01 muzzle device are licensed by Aeroknox Firearms. The ambidextrous fire selector makes the rifle friendly to both right and left-handed users.

The rifle has an air cushion type inner barrel which stabilizes the BBs and increases their rotation in the barrel, thus improving the range and accuracy of the replica.

Mechanism of Gearbox v2 with a quick spring change system mounted on 8mm steel ball bearings and rotary hopup. In addition, as a standard, these replicas are equipped with a Falcon electronic control system with programmable fire mode (Double Shot on SEMI mode or 1-5 Round Burst on AUTO mode), trigger sensitivity adjustment (3 modes) and motor and battery protection.

NOTE! Set the selector lever to SAFE mode before connecting the battery to boot the system.

Weight: 2300 g

Magazine model: steel

Gearbox version: v.2

Bearings diameter: 8 mm

Accumulator connector type: T-connerctor

Accumulator included in set: NO

Material: nylon, aluminum

Power: ~1J (328fps)

Fire mode: auto, single

Set included:

· AR15 replica

· 300rd hicap magazine

· folding sight set

· tamiya/deans connector adapter

NOTE! Please note that Battery and Charger are not included.

Compatible battery;

https://airsoftguns.ie/lithium-batteries/2420-battery-li-po-1200mah-74v-2040c-airsoft.html

Every replica pass initial check up. It's being checked and overshooted on XCORTECH X3200 chronograph.

The recommended battery with the highest safe voltage for this replica is -11.1V. If you decide to reduce the power, be sure to not use batteries with a too high voltage - 9.6V NiMH is recommended, and in the case of Li-Po / Li-Ion - 7.4V. Otherwise, the replica may be damaged, which will not be covered by warranty repair! Remember that the warranty covers only replicas in which the spring was not replaced with a stronger one, and no batteries with a higher voltage than recommended were used.