CYMA CM.040C AK74M AEG Airsoft Rifle (Black)

A replica of one of the most popular rifles in the world produced by a Chinese company, known for its reliability on the ASG market.

Inside there is a reinforced ver.3 gearbox, steel gears are mounted on reinforced 7mm bearings.

The spring guide is reinforced (metal), polymer piston has metal teeth.

A huge advantage is the silent piston and cylinder head set, made of aluminum and covered with a blue anode,the piston head has bearing.

The replica has a powerful engine with increased torque equipped with neodymium magnets.

The way how gearbox is functioning will surprise a user.

All parts and accessories of other manufacturers are fully compatible with this model, which is very important when you planing upgrade.

Weight: 2920 g

Magazine model: ABS

Bearings type: steel sliding

Gearbox version: 9 mm

Bearings diameter: 7 mm

Magazine model: hi-cap

Accumulator type: NiMH

Muzzle velocity: ~328fps

Accumulator type: stick

Accumulator connector type: small Tamiya

Accumulator included in set: NO

Diameter of Internal barrel: 6,03 mm

Magazine capacity: 525 BBs

Material: aluminum, steel

Color: black

Length: 950 mm

Muzzle energy: ~1J

Length of internal barrel: 490 mm

Fire mode: auto, single

Set Included:

* replica

* magazine hi-cap 525rd

The replica does not have a charger and a battery in the set.

NOTICE! Replica have a unique serial number!

Warrnig!

Adjustment rear sight only like in picture (green colour).

We don`t response for damages caused for bad adjustment (red colour)

Every replica pass initial check up.

It`s being checked and overshooted on XCORTECH X3200 chronograph.

The recommended battery with the highest safe voltage - 9.6V NiMH is recommended, and in the case of Li-Po / Li-Ion - 7.4V.

Otherwise, the replica may be damaged, which will not be covered by warranty repair!

Remember that the warranty covers only replicas in which the spring was not replaced with a stronger one, and no batteries with a higher voltage than recommended were used.

If you decide to reduce the power, be sure to not use batteries with a too high voltage - 9.6V NiMH is recommended, and in the case of Li-Po / Li-Ion - 7.4V.

Otherwise, the replica may be damaged, which will not be covered by warranty repair!

Remember that the warranty covers only replicas in which the spring was not replaced with a stronger one, and no batteries with a higher voltage than recommended were used.