Z Tactical Comtac I Headset
The Comtac headset is a double-earpiece communications interface with output sound in both ear and a microphone on an adjustable boom.
The Comtac headset is a double-earpiece communications interface with output sound in both ear and a microphone on an adjustable boom.
Double rifle gun case have two main pockets, bigger one have 120 cm long and shorter one have 93 cm long. It also can be used as backpack. Longer pocket have also a sleeve inside that can extend gun case for extra 27 cm.
The gun bag is made of nylon. Thanks to the application of the additional sleeve the cover will without any problem hold a gun that is up to 1300mm long. Inside of the main chamber there are two additional gun mounting bands. Inside the front 620x260mm big pocket we will fit a machinegun. The gun mounting bands are also located in it.
Gun case with two chambers for dual storage/transportation. Main chamber will hold rifle up to 960 mm long (or 1100 mm when utilising the external hood).Secondary chamber will hold a firearm up to 650 mm long.Case also has pockets that allow transporting magazine or other accesories.Case may be transported in ordinary fasion with use of transport handle...
The bag is constructed from durable and tough 600D nylon, which is capable of supporting the weight of two Airsoft weapons with ease. This practical carry case is ideal for any Airsofter who likes taking more than one Airsoft weapon to a skirmish, and keeping all of their gear together in one convenient bag.
Hydration system drink tube exit hole on top of the backpack. Strap and ring around the backpack, able to add-on pouches and accessories.
A very comfortable nylon made Assault Pack. Thanks to the good planning of the compartment and pocket placing the backpack is very capacious despite the rather small dimensions. The suspenders are adjustable in two ways: on the height of the shoulder and by the bottom of the backpack. The backpack can be taken off in a very easy and fast way thanks to...
Gun case with two chambers for guns. Main chamber will hold gun with lenght up to 800 mm (or 1100 mm with use of external hood) Secondary chamber will hold gun with lenght up to 580 mmCase has also pocket"s allowing for transport of magazine"s or other accesories
LED Module can change your Hopup chamber to be a tracer unit, No silencer type tracer unit anymore, shot illuminated BB without losing balance of weapon. Suitable for MADBULL Ultimate 3-in-1 Hop Up Chamber Unit
Madbull PWS Diablo Compensator -- Primary Weapons Systems, Inc (PWS) is a Federally-licensed firearms manufacturer -- T6 6061 Aluminum Construction
Name |
LiPo 7,4V 950mAh 20/50C
|
Cell Type |
LiPo
|
Battery Capacity [mAh] |
950
|
Battery Voltage [V] |
7,4
|
Plug Type |
Tamiya
|
Battery size [mm] |
13x25x70
|
Number of Cells |
2
|
NOTICE! Batteries are covered only by starting warranty.
Electro River™ is a new quality on the LiPo battery pack market. The manufacturer has set for himself a goal to create a product whose quality will match even the best players on the market of batteries whilst at the same time retaining an attractive price. The offer includes high capacity packs designed with limited space replicas in mind - new packs are similar to a lighter in size!
High quality wiring and connectors guarantee maximum exploitation of the energy potential of the battery by minimizing losses during energy transfer. Such a solution also prevents overheating of the contacts Every cell has a Nanosafe® safeguard in order to minimize the risk of potential fire of the pack as a result of damage.
Due to Subzero Power® technology, the low temperature efficiency has been increased. Even in temperatures below zero the level of self-discharge is very low. High quality craftsmanship of each cell and other elements provides minimal internal resistance and voltage durability under stress. The abovementioned features have allowed to achieve up to 20% more charging cycles than in other Li-Po batteries! This makes Electro River™ products a very attractive offer both for beginners and advance LiPo battery users.
Lithium-Ion-Polymer (LiPo) packs are successors to the known Lithium-Ion (LiIon) packs. The basic advantage of LiPo is undoubtedly the ratio of capacity to size. The packs are of very small size whilst maintaining a very large electric efficiency, which allows for choosing an appropriate pack for practically every AEG replica. Do not feature memory effect. Can be charged very frequently, without the need to be fully discharged. Frequent charging is beneficial for every type of a battery.
It is crucial to remember not to discharge a LiPo pack to a level of less than 3V per cell and not to overcharge over 4,2V per cell. Another advantage of LiPo packs is a small percentage rate of self-discharge. Unused pack will lose approximately 3-5% of energy per month. It is important to pay attention to an unused pack as there is a risk that as a result of not being used over a prolonged period of time it can be discharged beneath the acceptable minimal value (3V per cell) and inadvertent chemical reactions may occur, which lead to a deterioration of the pack’s properties including a permanent damage and, in extreme cases, fire. Unused LiPo pack should be charged to an average of 70%.
Properly used, a LiPo pack has a exploitation period of on average 500-700 cycles. An important factor is the temperature thatLiPo packs can work in. In contrast to other batteries, LiPo cells perform well in low temperatures. However, they should be charged in room temperature. In order to maintain the good condition of LiPo batteries it is required to balance them during charging with a service connector, which most LiPo packs have (a good LiPo charger features an in-built balancer).
Dimensions: 12,9 x 2 x 1,2 (cm x cm x cm)Capacity: 1200 mAhVoltage: 7,4 VMaximum discharge power (semi fire): 24AMaximum discharge power (auto fire): 48A
WARFET is GATE’s most advanced AEG Control System. It has 20 functions and almost 6 million possible configurations. The outstanding Tactical Programming Card provides you with very easy access to the WARFET Power Module settings. SUPER-EASY INSTALLATION - JUST PLUG&PLAY, NO SOLDERING REQUIRED
Battery 8.4V 1600 mAh New technologies have been developed in Ni-MH batteries, thanks to which higher efficiency and high voltage can be obtained. Ni-MH batteries form groups of batteries that are powerful, energy density, which is why at the same performance they have a greater capacity than batteries made in higher technologies. The package made of...
Set of 2.8x0.5 Flat Connectors [Female + Male]Two sets of flat connectors intended for installation in wiring or the motor of an AEG replica. The set includes 2 pairs of heat-shrink tubings.
Maximum intensity of discharge power:30AAccumulator type: metalAccumulator connector type: small TamiyaAccumulator cells type: lithiumAccumulator capacitance: 1500 mAhLength: 125 mmWidth: 20 mmAccumulator voltage: 7,4 VHeight: 6 mm NOTICE! Batteries are covered only by starting warranty.
Battery charger for NI-MH / NI-CD batteries. It has a signaling LED, the red color means charging and the green color - battery is full.
Cell Type LiPo Battery Capacity [mAh] 2000 Battery Voltage [V] 7,4 Plug Type DEAN Battery size [mm] 10x21x126 Number of Cells 2 NOTICE! Batteries are covered only by starting warranty.
Battery NiMH 1600mAh 10,V - stick type [8FIELDS] Accumulator type: NiMH Accumulator voltage: 10.8 V Accumulator capacitance: 1600 mAh Accumulator cells type: mini Accumulator connector type: small Tamiya NOTICE! Batteries are covered only by starting warranty.
This combo pack contains a 9.6v NiMH nunchuck battery and smart charger. The nunchuck configuration battery fits most airsoft rifles, and the smart charger will quickly charge and keep the battery topped off. Both have small type tamiya plugs that are common to most airsoft rifles as well. Please note; battery & charger can looks different (not...
Dimensions: 12,9 x 2 x 1,2 (cm x cm x cm)Capacity: 1200 mAhVoltage: 7,4 VMaximum discharge power (semi fire): 24AMaximum discharge power (auto fire): 48A
Redox Alpha V2 battery charger COMBO (with power supply) A new improved version of the popular Redox company’s Alpha charger. The Redox Alpha V2 is inter alia equipped with an actualized software ensuring a long and stable operation of the device. Additionally, a big radiator which discharges the heat very efficiently was mounted on the top of the...
Weight: 160 g Accumulator type: metal Accumulator connector type: small Tamiya Accumulator cells type: lithium Accumulator capacitance: 2300 mAh Length: 103 mm Width: 34 mm NOTICE! Batteries are covered only by starting warranty.
Multiprocessor Charger with a Balancer Material: Metal + Polymer Weight: 530g Measurements: 135x145x35mm Manufacturer: Electro River™ NOTICE! Charges are covered only by starting warranty.
Name LiPo 7,4V 2200mAh 20/40C Cell Type LiPo Battery Capacity [mAh] 2200 Battery Voltage [V] 7,4 Plug Type DEAN Battery size [mm] 15x35x103 Number of Cells 2 NOTICE! Batteries are covered only by starting warranty.
It has 8 functions. Thanks to its special coating, it is resistant to atmospheric conditions (Military Specification MIL-V-173C). Battery protection supports: Li-Po 7.4V / 11.1V / 14.8V. You can also disable the protection and use other batteries.
Redox Alpha V2 microprocessor battery charger A new improved version of the popular Redox company’s Alpha charger. The Redox Alpha V2 is inter alia equipped with an actualized software ensuring a long and stable operation of the device. Additionally, a big radiator which discharges the heat very efficiently was mounted on the top of the charger. It is...
Name |
LiPo 7,4V 950mAh 20/50C
|
Cell Type |
LiPo
|
Battery Capacity [mAh] |
950
|
Battery Voltage [V] |
7,4
|
Plug Type |
Tamiya
|
Battery size [mm] |
13x25x70
|
Number of Cells |
2
|
NOTICE! Batteries are covered only by starting warranty.